5.7 Hemi Oil Leak Under Intake Manifold 2026 Media All Files Direct

Begin Your Journey 5.7 hemi oil leak under intake manifold curated live feed. Free from subscriptions on our media hub. Dive in in a enormous collection of expertly chosen media showcased in unmatched quality, essential for first-class viewing gurus. With current media, you’ll always stay updated. Seek out 5.7 hemi oil leak under intake manifold expertly chosen streaming in fantastic resolution for a sensory delight. Become a patron of our media world today to peruse members-only choice content with at no cost, free to access. Experience new uploads regularly and delve into an ocean of original artist media designed for choice media buffs. Be sure not to miss distinctive content—get a quick download! Access the best of 5.7 hemi oil leak under intake manifold special maker videos with brilliant quality and special choices.

I've seen intake seals from other manufacturers and i've yet to see a factory use any sealant on them I was under the hood yesterday and noticed just a little bit of oil / dirt showing on the drivers side (front) of the manifold, and a little bit more at the other fasteners on. Nor have i seen any service manual recommend it

Oil Leak from Intake Manifold - Causes and Solutions

It is possible that chemicals in the sealant may attack the composition of the seal material Searched for any reference to this and didn't see any.anyone noticed oil leaks around the 5.7l intake manifold Intake manifold bolt torque spec is 105 in lbs for when you put it all back together

Spartan plus cam, inertia performance heads milled.020, eagle intake manifold, 6.1 crank pulley, jba shorty headers and high flow cats, getrag 3.06, mopar 6.1 cai, mopar tcm, bt catch can, trubendz cat back

I repair an oil leak on a 2016 ram 1500 with a 5.7l hemi After diagnosing the source of the oil leak I determine the leak is coming from the pcv chamber in the intake manifold. It seems i have some oil leaking on my 2016 ram 1500, i noticed an oil stain under the drivers side of my truck so i crawled underneath and snapped some photos

Without the risk of sounding like a total idiot, it looks like its leaking oil between the starter and the exhaust manifold 5.7 hemi common oil leaks by moparproud posted on august 18, 2022 updated on december 12, 2025 the chrysler 5.7 hemi engine is a v8 that was introduced in 2003 It is used in a variety of vehicles, including the dodge charger and challenger. 2019 challenger r/t 5.7 i recently noticed some oil around fuel injector 1, so i cleaned it off and kept an eye on the area

I was able to confirm there is a small leak, but not enough to see any noticeable fluctuation in oil levels

I will try to attach some images.i checked most of the bolts. 2003 dodge ram 1500 5.7 hemi intake manifold oil leaking from intake manifold 5.7 hemi more than likely a mds solenoid under the intake leaking pressurized oil if when you pull intake & there is a puddle of oil under. How much oil is inside the intake manifold Since you have the intake manifold off right now i'd check the mds plugs and make sure they're still in good shape, but i'd also check the pcv as well, if it's blocked or stuck open then it'll be pulling in oil in high vacuum which can account for large amount of oil being pulled into the manifold.

I have done some research on here and am trying to figure out an oil leak on my 2019 ram 1500 It's got about 68k miles on it now The drip is between the trans bell housing and the block It's not an rms as the weep hole is dry

It seems to be coming from the top passenger side of the motor and.

The intake manifold gasketing is pretty robust on hemi's, my guess is the leakage is related to poor installation of the manifold Be carefull tightening the bolts, torque spec is about 105 in/lb (a little less than 9 ft/lb). I got under my truck yesterday to check out how close my tires were to my front end components when the steering was turned one way or the other and noticed a tiny oil droplet on the area between my transmission and engine I followed it up to the top rear of the engine and found that the right rear corner of my intake manifold gasket is leaking.

My 2014 ram 1500 with about 50k miles is leaking a little oil down the back side of the motor passenger side Not much just enough to wet the area I read that the intake manifold bolts heat cycle and lose torque due to gasket compression and plastic heat cycle compression Thats one stepl as for the solenoids, for sure not leaking

When i had the intake off they were dry

The oil under the intake leaked by the side where i have shown in the photos In regards to the oil control valve, was dry there also I'm getting this oil only in the same spot as i have with the 2 previous intakes. Looks like oil pushing out probably around the valve cover and intake gasket seals

More than likely you have pressure building in the crankcase/engine and it's pushing oil out of the deal areas. It is common for oil to leak under the intake manifold through the engine oil filter housing In this particular case, oil is leaking through the solenoid pl. I noticed oil leaking on the passenger side bank and going down the back of the head when i was under my truck looking at my exhaust

I followed the oil up and it was higher than the valve cover

Pulled the engine cover and found wetness around the intake manifold right below the pcv valve. Major oil leak from under intake 1 reading jump to latest 3.8k views 20 replies 5 participants last post by bmcgeiser apr 22, 2025 How to remove oil from the intake manifold the first thing you'll want to do after finding oil in your car's intake manifold is to clean it out

And because the manifold usually has a complex shape, you'll have to remove it from the engine bay On may 5th i removed my intake manifold to check and see if my mds solenoids were faulty and leaking oil As you can see here they are leaking pretty bad but that's beside my point thats a problem i have to fix, i almost thought it was a rear main seal leak and panicked but instead it was these. So my factory intake manifold is leaking oil at the seem by the pcv (63,000 miles)

A new oe 5.7 manifold is not cheap when compared to doing the 6.4 swap.

With the way the intake manifolds sit on these engines id doubt its a leak at the manifold most likely if it is a leak it will be at the top of the valve cover If your dip stick is reading at the bottom of the safe zone then either the oil was not topped off at the last change or you do have a serious leak that needs to be found and fixed. Noticed for the first time today i had a small pool of oil under the intake manifold on my basically stock 09 5.7 with 12000 miles I'm assuming this is extra blow by vapors somehow leaking out on to the top of the motor?

I have a 2007 gc overland with the 5.7 hemi and 195k miles on it It has developed an oil leak on top of the engine, near the oil filler The depressions holding the intake manifold bolts are filled with oil, and it runs down on the exhaust manifold and smokes when i am at stoplights. While installing my moe's ported tb, i noticed oil collected at the bottom of the manifold

I checked the main oil vapor return line that feeds into the k&n cai & did not see any oil

My thoughts are it is either entering there as vapor (though the entire cai tube was dry), or from one.